FDM Ordering Guide
Material Selection
ABSPLUS-p430
Production-Grade Thermoplastic
ABS Plus-P430 is a true production-grade thermoplastic that is durable enough to perform virtually the same as production parts. This material has stability over time since it’s a production-grade thermoplastic.
Build Resolution Selection Options
Low Resolution
0.013" Z, 0.015" X, 0.015" Y
Standard Resolution
0.010" Z, 0.015" X, 0.015" Y
TOLERANCE
X/Y Planes: ± 0.005″ for the first inch, plus ± 0.002″ for every inch thereafter.
Z PLane: ± 0.010″ for the first inch, plus ± 0.002″ for every inch thereafter.
basic finish
Basic – All supports are removed
ADVANCED FINISH OPTIONS
Primed
- All supports are removed
- Support surface is lightly sanded
- Stair stepping (layer lines) ARE NOT removed
- Primer is applied for a ready to paint surface. Unless otherwise requested, only the outer surfaces are primed
Quick Paint
- All supports are removed
- Support surface is sanded
- Stair stepping (layer lines) ARE NOT removed
- Paint is applied as per customer supplied PMS color numbers. If a multi-color model is required, a JPEG file or document depicting the paint scheme is preferred.
Standard
- All supports are removed
- Part is sanded to remove the heaviest of the stair stepping (build lines) on the exterior or outside surfaces of the part
Presentation
- All supports are removed
- Part is sanded to remove all stair stepping (build lines) on the exterior or outside of the part.
- Paint is applied as per customer supplied PMS color numbers. If multi-color model is required, a JPEG file or a document depicting the paint scheme is preferred.